12/10/2023 0 Comments Make a t slot bolt![]() ![]() However, you'll typically have to cut them down because they are usually quite long. In a pinch, you can use toilet bolts from the hardware store. I think the cost savings in not having to purchase the track makes up for the cost of the bolts (which I often reuse by moving from one seldomly used jig to another). ![]() However, most of my jigs don't require too many of them. The problem w/ t-slot bolts from Rockler is that they're kinda pricey. This allows you to get them very tight without the risk of pulling them through. As you tighten the t-bolts in the slot, they turn a little bit so the bolt flats have more to grab on in the slot. The heads of the Rockler t-bolts are a hair over 1/2" wide, and the Rockler bit cuts a 5/8" slot. I think tightening the apparatus would cause the head of the bolt to pull right through. I don't think the 1/4" hex head has enough material to work in a wooden t-slot. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |